4 years ago - Translate

Pull out the vernier to check the oil level. The height of the liquid level after adding water should not exceed the full level. The dirty air filter should be replaced in time. Six, tire inspection The tire pressure should be checked at room temperature every month.

When adding brake fluid, pay attention to adding the same type of brake fluid to prevent damage to the cup, and pay attention to protect the paint to prevent corrosion of the paint surface. Maintenance and inspection of battery Check whether the battery is firmly fixed, the electrolyte should be between the upper limit and the lower limit, and the electrolyte or distilled water* high level line should be added in time when it is close to the offline.

If it is found that the cooling fluid decreases rapidly in a short period of time, check the cooling system for leaks or go to the maintenance station for inspection.When the engine is running, it will be difficult or impossible to shift gears. There is no rupture and leakage phenomenon. Seven, belt inspection When starting the engine or driving the vehicle in normal times, the belt hums. For vehicles that have been stored for a long time, remove the positive and negative cables of the battery, and re-wire the battery after about half a month to start the engine.

The air pressure cannot be too high or too low, otherwise it will affect the safety of driving. Inspection of brake fluid level If the brake is also between the high and low positions, it means normal. If an abnormality is found, the gap should be adjusted or the spark plug nonferrous casting parts Manufactures should be replaced. Otherwise, distilled water or pure water (mineral water cannot be added) or refrigerant should be added. Inspection of the air filter If the air filter is too dirty, it will cause poor engine operation, excessive fuel consumption, damage to the engine, etc. When choosing tires, make them the same model.

Engine coolant level inspection Never open the radiator cover when the engine is in a warm state, otherwise you may be scalded by the spilled coolant or high-temperature steam.8+-0. If the brake fluid is close to the lower limit or lower than the lower limit, it means that there may be a leak in the system or the brake shoes are worn too much, and you should go to the repair station for maintenance in time. Check the tires for cracks, and replace the tires in time if there is a safety hazard. The specified type of oil should be added, and the liquid level after refueling cannot be higher than (F) level