Installation precautions for rubber conveyor belts
After purchase, the rubber conveyor belt needs to be installed on the conveyor before it can be used. It must be reasonable during the installation process to ensure the normal operation of the conveyor belt. So what should be paid attention to during the installation of the rubber conveyor belt? The following conveyor belt manufacturers take everyone to understand in detail.
Whether the new belt or the old belt is replaced when the rubber conveyor belt is installed, if the installation of the entire conveyor belt is not carefully planned and calculated in advance, it may easily cause the incorrect connection of the conveyor belt, resulting in slippery starting or wasted waste of the conveyor belt. Causing unnecessary losses.
The supervision of the adhesive bonding of the joints of the conveyor belt is the most important part in the installation process of the chevron conveyor belt. Belt breakage accidents caused by the quality problems of vulcanized joints occur from time to time, which not only affects production, but also causes personal accidents. After the rubber conveyor belt is installed and used directly on the machine, the newly installed conveyor belt is prone to local wear when it is not running and running in.
When the endless rough top conveyor belt is bent, first check whether the three holders of the flat vulcanizing machine are in a straight line, especially the nylon core and E core must be cold-set and stretched twice. When the clamping angle of the fixed extension is not 90 degrees, it will often cause a curved belt. Therefore, the angle of the operator is not correct when stretching, or the gripper is loose and tight at the same time, which may also cause a curved band. In addition, the thickness of the blank is too large. The thick side is thin, and the thick side is compressed slightly longer than the thin side when vulcanized. Each plate accumulation will cause the thick side of the blank to sing, and the thin side will be short. , Thus causing bending. When the green belt is vulcanized, if it is put into the mold frame incorrectly, it will be deflected, which may also cause a curved belt.
https://www.sjbelt.com/product..../conveyor-belt/heat-
